Installation, Operation & Maintenance InstructionsPlease leave this instruction booklet with the owner as it contains important guarantee, mainten
- 10 -Cont ...3 PUMP CONNECTIONS3.11 Pump to pipework: Connect the pump to pipework using a G1 to 22 mm connector as shown in Fig. 1.
- 11 -Cont ...4 ELECTRICAL INSTALLATION / EARTHING4.11 Regulations: The electrical installation must be carried out in accordance with the cu
- 12 -4.21 Wiring Diagrams:Model Fuse Size (AMPS)PHD FL 13All other models 54.22 Fuses: The following fuse size should be used with the appropriate
- 13 -Cont ...5.14 Starting: a) Switch on power and open terminal fitting. Pump should start and stop upon demand. b) Open and close all out
- 14 -Cont ...6 MAINTENANCE6.11 Turn off water supplies to the pump and release pressure by opening water outlets before attempting maintena
- 15 -7 TECHNICAL SPECIFICATIONStuart Turner reserve the right to amend the specification in line with its policy of continuous development of its pro
- 16 -Cont ...8 TROUBLE SHOOTING GUIDESymptoms Probable Cause Recommended ActionPump will not start. Insufficient gravity flow. Check flow rate minim
- 17 -Cont ...8.11 Flow Switch Circuit Test: 1. First confirm visually that the flow switch reed clamps have not been dislodged during handl
- 18 -9 YOUR 1 YEAR GUARANTEEStuart Pumps are guaranteed by Stuart Turner Limited to be free from defects in materials or workmanship and the guarant
- 19 -NOTES
- 2 -PRODUCT DESCRIPTIONElectric motor driven centrifugal pump complete with an automatic control system, consisting of flow switches and electronic c
DECLARATION OF CONFORMITY2006/42/ECBS EN ISO 12100-1, BS EN ISO 12100-2, BS EN 8092006/95/ECBS EN 60335-1, BS EN 60335-2-412004/108/ECBS EN 55014-1, B
- 3 -CHECKLISTYour product may vary slightly from the picture above.ItemDescription QtyItemDescription QtyPump 1 Anti-vibration feet 3Chip Foam Pad 1A
- 4 -Cont ...1 READ BEFORE COMMENCING PUMP INSTALLATIONA. Water storage capacity.1.11 The water storage capacity (must be a minimum of 230 litres)
- 5 -Cont ...2 LOCATION - GENERAL2.11 Access: For emergencies and maintenance the pump must be easily accessible.2.12 Protection: The pump must
- 6 -2.26 Non-Preferred Pump Location: The pump must be located with at least 1 metre flooded suction at all times. If it is not possible to loc
- 7 -Cont ...2 LOCATION - COLD WATER INSTALLATION2.28 The cold water supply: The supply must be AIR FREE and have a DEDICATED CONNECTION to
- 8 -Cont ...2 LOCATION - HOT WATER INSTALLATIONFig. 5Static inlet pressure 14 metres max1 metre minpreferredareaOutlet head must be below bottom of
- 9 -Cont ...2.29 Hot water supply: The pump must be supplied with a dedicated feed direct from the hot water cylinder or storage tank which sh
Comments to this Manuals